高效液相色谱法测定化妆品中依克多因的含量

建立高效液相色谱法测定化妆品中依克多因的分析方法,采用Agilent Poroshell 120 EC-C₁₈色谱柱（100 mm×3.0 mm,2.7μm）分离,以甲醇和p H为3.0的40 mmol/L磷酸二氢钠-10 mmol/L 1-庚烷磺酸钠缓冲溶液梯度洗脱,流速0.8 m L/min,柱温30℃,检测波长210 nm。采用外标法定量测定化妆品中的依克多因含量。结果表明,依克多因在5～800 mg/L的质量浓度范围内呈现良好线性关系,相关系数为0.999 8,方法的检出限和定量限分别为0.3和1.0 mg/L。该方法具有分离效率高、分析时间短、节省溶剂等优点,解决了依克多因在C₁₈色谱柱上保留弱的问题。     

Phosphorus-doped silicon nanoparticles as high performance LIB negative electrode

Journal of Materials Science - Silicon is getting much attention as the promising next-generation negative electrode materials for lithium-ion batteries with the advantages of abundance, high...     

四氢姜黄素经PI3K/Akt信号通路对人血小板活化和聚集的调控作用

目的：探讨姜黄素的主要肠道代谢物四氢姜黄素（tetrahydrocurcumin，THC）对血小板活化和聚集的影响及其可能的分子机制。方法：在体外实验中，用不同浓度的THC（0、0.5、1、10 μmol/L）提前与健康人纯化血小板共同孵育40 min，然后加入凝血酶激活血小板2 min，用流式细胞术测定血小板表面CD62P和CD63的表达量，用酶联免疫吸附法测定血小板释放血小板因子-4（platelet factor-4，PF4）和趋化因子配体-5（chemokine ligand 5，CCL5）水平，用血小板聚集仪检测血小板释放ATP水平和血小板最大聚集率，用Western blot蛋白免疫印迹法检测血小板磷酸肌醇-3-激酶（phosphoinositide 3-kinase，PI3K）和Akt蛋白的磷酸化水平。结果：与模型组（血小板悬液中加入0.05%二甲基亚砜）相比，THC能抑制凝血酶诱导的血小板表面CD62P和CD63的表达，抑制PF4、CCL5和ATP的释放，降低血小板最大聚集率，下调PI3K和Akt蛋白的磷酸化水平，且呈浓度依赖效应，其中10 μmol/L的浓度下作用效果显著（P＜0.01、P＜0.001）。PI3K的特异性激动剂740 Y-P可部分逆转THC对PF4和CCL5释放和血小板聚集的抑制作用（P＜0.05、P＜0.01）。结论：THC具有显著抑制血小板活化和聚集的作用，其机制可能是THC可下调PI3K/Akt介导的信号通路。     

Fabrication of high-efficiency Yb:Y2O3 laser ceramics without photodarkening

High-efficiency Yb:Y₂O₃ laser ceramics were fabricated using the vacuum-sintering plus hot isostatic pressing (HIP) without sintering additives. High-purity well-dispersed nanocrystalline Yb:Y₂O₃ powder was synthesized using a modified co-precipitation method in-house. The green bodies were first vacuum sintered at a temperature as low as 1430°C and then HIPed at 1450°C. Finally, the samples were air annealed at 800°C for 10 h. Although no sintering aids were used, full density of the samples with excellent optical homogeneity and an inline transmission of 80% at 400 nm could be obtained. Moreover, photodarkening phenomenon was not detected in the ceramics. Preliminary laser experiment with the fabricated ceramics in a two-mirror cavity has demonstrated 32 W continuous-wave (CW) output at ∼1077 nm with an optical-to-optical conversion efficiency of 58.2%. To the best of our knowledge, this is so far the highest CW output power and optical-to-optical conversion efficiency achieved with the Yb³⁺-doped sesquioxide ceramics in a simple two-mirror cavity.     

碳纤维原丝含油率测试影响因素研究

利用改进的索氏提取回流法测量碳纤维原丝含油率.研究了溶剂回流温度、回流时间、环境湿度对测试结果的影响,结果表明:随着回流温度的提高,2小时内回流清洗效果不断增强,当回流温度大于54℃,次数大于12次,油剂清洗效果基本保持不变.可通过提高回流温度以提高单位时间内的回流次数,优化纤维含油率测试的准确性和测试效率.环境湿度对索氏提取测纤维含油率有显著影响:控制环境湿度在50～52％RH范围内,可将纤维吸潮质量变化控制在纤维质量的0.005％,油剂相对含量的0.2％～0.6％,可将测试稳定差值降低至≤0.05％,测试方法差值<0.1％,满足油剂测试工艺要求.回流时间≥2 h,回流温度≥54℃,测试环境湿度50～52％RH,索氏提取回流法油剂测试误差<0.05％.